EMUGE埃莫克防松自锁螺纹丝锥量规通止规塞规
EMUGE埃莫克防松自锁螺纹丝锥量规通止规塞规
用于SELF-LOCK螺纹量规通/止规 ·Thread Gauges Go/No-Go for SELF-LOCK Threads
无锡诺和锐特自动化设备有限公司--官方授权代理商
全国免费服务热线:400-101-6010 / 187-6152-0653
QQ:3172115428
E-MAIL: dafengyangfan@163.com
地址:江苏省 无锡市国家高新技术产业开发区纺城大道288号
EMUGE的SELF-LOCK自锁螺纹量规
我们推荐使用我们的二件式量规系统,其类似通用的量规
通规和止规的组合体,对于如果该自锁螺纹是使用EMUGE的
丝锥加工出来的螺纹检测完全足够了。
对于EMUGE自锁螺纹,这里没有一般适用标准(例如:DIN标准)。
因此对于这些螺纹,其它制造商可以使用不同的极限尺寸。
基于这个原因,我们推荐:检测EMUGE自锁螺纹时,使用EMUGE自锁量规。
The gauging of the EMUGE SELF-LOCK thread
We recommend using our two-piece gauge system which corresponds to the
usual combination of go and no-go gauge and is perfectly sufficient for the
gauging of the thread, provided that the LK threads were produced with our
true-to-profile EMUGE taps.
There is no generally applicable standard (e.g. DIN standard) for the EMUGE
SELF-LOCK thread, so other manufacturers may use different limit sizes for
their threads. For this reason, we recommend gauging EMUGE SELF-LOCK
threads exclusively with EMUGE SELF-LOCK gauges.
锯齿螺纹的检测具有相同的原理,唯一的不同之处是塞规通规和止规都必须在正确的方向下使用。
The gauging of the saw-tooth profle works on the same principle, with the only difference that both the go and the no-go plug gauge have to be used in the correct direction.
如果通过雕刻或螺纹铣削加工的螺纹,我们推荐额外使用EMUGE HPRG量规,来检查斜坡的最低根部,并且有助于鉴别斜坡的角度任何偏差。
If chasers or thread milling cutters are used, we recommend using an additional EMUGE HRPG gauge. This gauge serves to check the lower ramp point or possible ramp angle errors.